Michael O'Hair
2009-02-18
Whenever you're making holes, especially in areas of vibration, remember to
chamfer the holes on both sides to relieve stress and smooth the cutting
edges. A tapered round file (rat tail) works best, but I've used 100 grit
sandpaper rolled into a cone with success.
----- Original Message -----
From: jmsmech-obra@yahoo.com
making one of these is as simple as flat narrow slightly heavy gage sheet
metal,some hole drilling and bending. if you have the tools, should take
about 5-10 minutes to make. for simplicity a two holes in the fender
matched to two holes in your bracket, loop a zip tie through. smooth sharp
edges or it will cut through tie sooner or later.